Adaptec 5325301656 - Snap Server 14000 NAS, Administrator'S Manual

Page: 72 / 224

Disks and Units
58 Snap Server Administrator Guide
Replacing a Disk Drive on a Snap Server 510, 520, 550, 650, or SANbloc S50
1
Remove the front bezel by pressing in the latches on each side of the bezel and
pulling the bezel away from the chassis.
2
On the closed handle of the failed disk drive, press the button in and to the left to
release the latch.
3
Open the handle and pull to remove the drive from the chassis.
4
Release the latch on the new drive and open its handle. If the handle is closed,
you cannot insert the disk drive completely into the bay.
5
Insert the new disk drive, making sure you push it forward until it is firmly
seated and the handle begins to swing closed. Then close the handle until it clicks
into place to completely seat the drive to its connection.
Note
Be sure to push firmly on the drive to securely seat it in the drive bay before
you close the handle. You should hear a click to indicate the drive has been
inserted as far as it can go.
6
Replace the front bezel.