C-1
C
▼ ▼ ▼ ▼
Troubleshooting
Troubleshooting Checklist
Check the following if you have problems installing or running the
ARO-1130U2 and SCSI devices:
■
Does the ARO-1130U2 BIOS sign-on message appear during
bootup? If not, check the following items:
–
Is the ARO-1130U2 properly seated in a RAIDport
expansion slot? Refer to your computer documentation for
the slot location.
–
Does your computer CMOS setup require you to enable
PCI bus parameters (see your computer documentation)? If
so, run the CMOS Setup program and assign the parame-
ters—usually IRQ, Enable PCI Slot, and Enable Master.
–
Have you run the Array1000 BIOS & Driver Selection Utility?
■
Is the SCSI bus terminated properly, and are all SCSI devices
turned on?
■
Are all SCSI bus cables and power cables connected?
■
Does each channel and each device on the channel have a
unique SCSI ID?
■
If you are having trouble booting from a SCSI disk drive or
array, make sure your computer’s CMOS setup is set to No
Drives Installed
(the required setting for SCSI drives). Also,
verify that the drive or array has been selected as the boot-first
(boot) device and has boot order # 0.
