7-2
ARO-1130U2 Installation and Hardware Guide
Installing the Array1000U2 Driver for UnixWare
To begin driver installation, see either Installing the Driver When
Installing SCO UnixWare below, or Installing the Driver When SCO
UnixWare is Already Installed on page 7-3.
Installing the Driver When Installing SCO UnixWare
To install the
cda1000
driver at the same time you install SCO
UnixWare, follow the instructions below:
1
Insert the SCO UnixWare Installation Diskette in the floppy
boot drive. Reboot your computer.
Wait for the first SCO UnixWare installation screen and prompt
to appear, then follow the onscreen instructions.
2
When prompted to Install HBA Diskette, first remove the
Installation Diskette, then insert the appropriate Adaptec
Array1000U2 Family Manager Set driver diskette for SCO
UnixWare (Disk A or Disk B) into your floppy disk drive (See
Running the Array1000 BIOS & Driver Selection Utility on page
3-2 to determine the appropriate driver diskette.)
3
Select Install HBA Diskette and press F10.
4
If you have additional HBA diskettes, insert the next HBA dis-
kette, select Install HBA Diskette and press F10.
If all of your HBA diskettes have been installed, select Proceed
With Installation
and press F10. (Do not reinstall the
cda1000
HBA diskette.)
5
If necessary, enter the DCU (Device Configuration Utility) to
view/change the SCO UnixWare device driver configuration
data; otherwise select Continue With Installation.
Note:
If you used Disk B of the Adaptec Array1000U2
Family Manager Set driver diskette for SCO UnixWare
in Step 2 above, enter the DCU to edit the Hardware
Device Configuration before continuing with installa-
tion. See Editing Hardware Device Configuration in DCU
on page 7-4 for instructions.
