ADE- 2022-C
Page 24 of 50
The runner can now be removed from the drawer, extend the runner slightly, and with
a firm grip twist the runner toward the middle of the drawer, this will allow the front of
the runner to be lifted clearing the front fastenings, pull the runner forward to clear
the rear fixing. See figures below.
Figure 24a: Twist runner. Figure 24b: Lift and pull forward
Figure 24c: Fixings in vertical wall supports and lancing’s in runner outer beam
Replacing the runner is the reverse of the removal procedure, engage the rear lancing
of the runner in the back vertical wall support and push horizontally to fully engage
the rear lancing, engage the middle and front lancing’s in their associated vertical wall
supports and press down on the runner sharply, it should engage in the front vertical
wall support with a ‘CLICK’, you should now not be able to lift the front of the runner
vertically.
Fit the container support in the same way by engaging the rear fixing first with a
horizontal motion then engage the front 2 lancing’s and press down to fully engaging
both, ensure the hole in the front of the runner lines up with the hole in the container
support, and refit the M5 X 6 countersink screw, once you have done this you will also
need to refit the brace container support rear with four off M5x8 bolts.
If required the runner can be lightly greased with food grade grease.
