ADE- 2022-C
Page 17 of 50
1
11
14
4
4
4
Evaporator Fan Replacement
Evaporator Fan Replacement
Evaporator Fan Replacement
Evaporator Fan Replacement
Once the diffuser is removed, the small evaporator fans can be removed first by
cutting the wires at the FAN
FAN
FAN
FAN end and use these to pull through the wires attached to
the new fan. Now remove the four self tapping screws that hold the fan in place as
shown in
figure 17a
.
The fan wires need to be disconnected from the 12volt power supply within the
controller enclosure, pulling the new wires through the hole in the lid (as shown in
figure 16c below) fit bullet crimps to the new fan wires and connect to the 12volt
power supply, mount the fans back on the diffuser as shown below in
figure 17b
.
Replace all cable ties.
Figure 17a: Evaporator fans
4 Off per Fan Self Tapping screws
hole in lid for all wiring
Figure 17b
Figure 17c
