Installation and Commissioning Guide
Hercules Package Unit
31
Installation and Commissioning Guide - Hercules Package Unit
Doc. No.0525-021
Ver. 21 221110
15.02. Control Interface (CP10) Remote Mounting Procedure
CAUTION
Static Sensitive Electronic Devices !
DO NOT handle electronic devices unless you are wearing an Anti-Static Wrist Strap that is connected to a GOOD EARTH.
Failure to protect the electronic devices from static electricity may cause unrepairable damage.
Static damaged electronic devices are NOT COVERED for replacement under warranty.
The typical connection between the control interface and the control board is made using 6 Core Flat 7/012 (AWG28)
Telephone Cable. To make the connection, simply plug the cable unto the 6-pin receptacle of the controller until it
clicks into place. To remove the connector, lightly press the plastic tab and pull out the connector. The telephone
cable provides both the data link and the power supply to the control interface as the simplest connection method.
For complex connection, where more than one terminal is connected to the CM100 Controller or to cover lengths in
excess of 50 meters, a 6 Core (3 Pair) Twisted Pair 7/0.20 (AWG24) Shielded Data Cable is required (to be provided by the
installer).
Shielded cable must also be used if the controller is installed in domestic or similar environments, and consequently
subject to ACMA EMC requirements.
15.02.01. Control Interface (CP10) Dimensions and Mounting Details (ActronAir
Supplied)
FRONT VIEW
Esc
Prg
82 mm
156 mm
TOP VIEW
125 mm
2 x ø 2.5 mm Holes
134 mm
127 mm
69 mm
34.5 mm
SIDE VIEW
18 mm
30 mm
67 mm
15.02.02. Control Interface (CP10) Remote Mounting Procedure:
A. Panel Mount
SCREW
(2-off)
PANEL
MOUNTING HOLES
(2 x ø2.5 mm)
COVER - CONTROL
INTERFACE
CONTROL
INTERFACE
PANEL
MOUNTING CUT-
OUT
(127 mm x 69 mm)
