ActionTec R1020S(U), User Manual

Page: 3 / 37

5
Before you Connect the Home Gateway
lV
lll
4
Introduction to the Home Gateway
Description of the LEDs and Reset Switch
Power LED: If it is off then there is no power to the Home Gateway or a critical error
has occurred. (Contact Technical Support if this happens) If it is Rapidly Flashing, then
the Home Gateway is initializing. If the LED is a solid green then the Home Gateway
is fully operational.
Internet WAN LED: If it is off, then there is no physical connection to the broadband
modem. If it is on, then there is a connection to your broadband equipment.
Ethernet LAN LED: If it is off, then there is no link, and if it is on, there is a link. If it
is flashing, then there is data being transmitted or received.
Reset Switch: If you would like to reset your Home Gateway, hold down the switch for
1 to 2 seconds. If you would like to restore the Home Gateway to its default settings
then hold the switch down for 10 seconds.
Introduction to the Home Gateway
Power
Internet/WAN
Ethernet
Network
LAN
PC Card
You will need specific information from your ISP to configure the Home Gateway. You can
obtain most of this information from your broadband configured PC by following these 4 steps.
Note: If you have previously installed Internet Connection Sharing (Ex.
Microsoft ICS) or Proxy Server software (Ex. WINPROXY) you will need to
uninstall them now.
1. Click Start , then Run
Before you Connect the Home Gateway
2. Enter WINIPCFG in the field and click OK