AFTER SALES SUPPORT
1800 465 070
MODEL: S002146
28
Maintenance (cont)
Adjusting the Motor Belt
During your workout, if you find the running belt is not running smoothly then it means that the motor belt is
loosened. To solve the issue please follow the below steps to adjust the tension.
Turn the motor belt adjustment bolt clockwise ¼ turn using the 6 Allen Key (104). Re-start the treadmill and run
on the treadmill. If the running belt is still not working properly then repeat the above step until the running belt
functions properly.
NOTE: Be careful not to tighten the motor belt too much as this will cause the treadmill to overload and will
reduce the life of the motor.
Deck Lubrication
The treadmill is pre-lubricated. However, it is recommended to check the lubrication of the treadmill regularly, to
ensure an optimal operation of the treadmill. After every 2 months of operation, lift the side of the running belt and
feel the underside surface of the belt, as far as possible. If traces of silicon lubricant are found, further lubrication
is not necessary. In case of a dry surface, refer to the instructions below.
Only use 100% silicon oil to lubricate
your treadmill deck.
To apply lubricant on the belt, position the running belt so that the seam is located in the middle of the running
deck. Lift one side of the belt and apply approximately 1/3 of the bottle of the supplied Lubricating Oil (105) under
the centre of the running belt and on the top surface of the running deck. Turn on the unit and walk on the treadmill
for 3-5 minutes at a low speed to evenly distribute the lubricant. Wipe off any excess lubricant that is visible on the
running deck outside the edge of the running belt.
NOTE: Do not over lubricate the running deck.
