10
/ 42
Product Overview
WARNING
Only trained personnel should operate this equipment. Read all
documentation and procedures before installation or operation. This
product is intended for installation and operation in a restricted area.
Only personnel with technical and product safety training should be
provided access to the library. Such personnel are referred to as users
throughout this document. Do not insert any tools or any part of your
body into openings of an operating system.
AVERTISSEMENT
Cet équipement ne doit être utilisé que par un personnel formé. Lisez la totalité
de la documentation et des procédures avant toute installation ou utilisation. Ce produit est conçu
pour l'installation et l'utilisation dans un rack d'ordinateur avec les portes avant et arrière fermées
et sécurisées. Seul un personnel avec la formation technique et de sécurité des produits est autorisé
à accéder à la bibliothèque. Ce personnel est désigné par utilisateurs dans la totalité de ce
document. N'insérez pas d'outils ni partie du corps dans les ouvertures d'un système en marche.
All actiLib Kodiak 3407 installations begin with the 3U high Base Module, with capacity for 32 tape cartridges
and 3 half-height LTO tape drives.
actiLib Kodiak 3407 is expandable, allowing a user to grow their tape storage capacity as their data
requirements increase. As data storage needs grow, actiLib Kodiak 3407 can also grow by adding one or
more 3U high Expansion Modules
.
Each Expansion Module provides an additional 40 tape cartridges and
supports an additional 3 half-height LTO tape drives.
Up to 6 Expansion Modules can be added to a Base Module, bring the total library capacity to 272 tape
cartridges and 21 half-height LTO tape drives.
Supported Library Configurations
–
Rackmount Installation
All actiLib Kodiak 3407 Libraries start with a Base Module. Up to 6 Expansion Modules can be added as
needed to support customer requirements. The architecture has been designed to support a maximum of 3
Expansion Modules above and 3 Expansion Modules below. The Base Module must be mounted with 9U
of empty space about and 9U of empty space below to ensure a full stack can be installed. Table 1 shows
the supported configurations for libraries ranging from one to seven total modules.
The Base Module is depicted by the following image with the Operator Control Panel shown in yellow:
Each Expansion Module is represented by the following image with a large clear viewing window in the
center.
