ACTpro 3000 Operating Instructions
Firmware Version 1.24
34
ACT Modem Configuration
DB25 Male
(Rear View)
7
3 2
Max cable length is 5m using standard alarm cable
or 30m using twin twisted-pair (use 0V in each pair)
Direct Connection from Modem to Controller
Connections for 25 Way male Connector
RX = Pin 3
TX = Pin 2
0V = Pin 7
1. Connect Modem Cable directly
to ACTpro 3000 and Modem
2. In Communications Menu Set:
Address = 1
Direct Conn = Y
3. Controller is now ready to receive calls
1. Connect the ACT modem to the PC and install modem driver.
2. In ACTWin pro, Click on the
Locations and Connections
icon on the toolbar.
3. Configure the remote site name in the
Location Name
.
4. Select the
Type of Connection
as Modem.
5. Enter the remote sites' telephone number.
6. Select the newly installed modem as the
Dialup Modem
.
7. Set up remote controller(s) in the Controller View. Set the location as the remote site name.
6. The controller(s) will appear under the remote site name in the System View window.
7. Double click on the telephone icon beside the remote site name in System View window.
8. Modem will now contact remote Site and connect to the controller(s).
9. To finish the call, click the disconnect button on ACTWin pro
ACTWin pro Setup for Modem Operation
ACT Nework Interface Card
Line 1
Line 2
Line 3
Line 4
S
C
N
C
D
I
D
O
+BAT-
~AC~
RS485
RS485
RS485
232 Interface
232 Interface
Converter
Converter
LED2
LED3
RS232
PORT
Connections for 25 Way male Connector
Modem Connection for ACT Network
DO = Pin 2
DI = Pin 3
C = NC
SCN = Pin 7
DB25 Male
(Rear View)
7
3 2
1. Connect Network Modem Cable to ACT Network card and Modem
2. In ACTpro 3000 Communications Menu set the controller Address
and set Direct Conn = N
3. Controller(s) now ready to receive calls
A
B 0V
TX
RX
NETWORK 1
D
O
O
R
S
A
B
0V
S
E
R
IA
L
/P
R
IN
T
E
R
0V
DTR
ACTpro 3000
A
B 0V
NETWORK 2
CTS
