ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
43
5 .10 .1 .3
Receive firmware update
The internal software of the device (firmware) can be updated by a new firmware, which could include
functional improvements, functional extensions, new functions or also customer specific modifications.
At the file transmission the safety of the power supply must be ensured. A power fail can lead to a
completely irreversible device failure.
5 .10 .1 .4
PIN
For a protected resp. encoded data transmission a PIN must be input.
The input range is limited to values from 000000 to 999999.
Default > no PIN allocated
5 .10 .1 .5
Visibility
To transmit a file to the device, it must be visible in the Bluetooth network. Other end devices can
identify only visible devices.
Default > Off
5 .10 .2
Record value
The measuring value can be alternatively recorded as distance, as filling level, percentual, with any
desired scaling referring percentual to the measuring range or by displaying the analogue output
value.
•
Distance
•
Filling level
•
Percent
•
Scaled
•
Signal output
Default > Distance
5 .10 .3
Storage interval
The storage interval defines the time interval between two measuring values, which should be stored
in the measuring value memory.
The input range is limited to values from 1 to 99999.
Default > 60 s
5 .10 .4
Activation Recording
To start the recording of measuring values, this must be activated.
•
Always
Each measuring value will be stored at the set storage interval.
•
Deactive
The measuring value recording is switched off.
•
Threshold value
The measuring value recording at the set storage interval will be switched on at overrun of the
set threshold value (menu „Active over“) resp. switched off at underrun of the set threshold
value (menu „Deactive under“)
The input range is limited to values from 1 to 99999.
Default > 0.000
Default > Deactive
5 .10 .5
Delete measure data
All existing stored measuring values in the measuring value memory are erased.
5 .10 .6
Quantity counter
The quantity counter integrates the calculated measuring values from the display scaling by the time.
These values are stored every second.
If the eventually activated impulse output cant output all impulses time conformal due to a too high
frequency, all impulses are output afterwards until all accumulated impulses could be output, also if
the flow is already lower or has stopped. Thus the amount of output pulses fits always to the quantity
counter. Nevertheless this should be avoided from the first by a correct setting.
Summary of Contents for Sonicont USN4SP
Page 58: ......
