Acroprint ATR360, User Manual

Page: 16 / 34

12
Set Ink Color Change Time
1. Remove top cover
2. Locate the program switch to the left of the finger print reader. Move the switch to the down
position, you are now in setup mode
3. Press P1.
a. P1,P4,P5,P6 will now be flashing
4. If this is the initial setup you must begin with 01
5. Press P6 to save
6. Press P4 or P5 to select the correct hour
7. Press P6 to save
8. Press P4 or P5 to select the correct minute
9. Press P6 to save
10. Press P4 or P5 to select the correct color
a. 01 – Black
b. 02 – Red
11. Press P6 to save
12. Deselect days by pressing P4 or P5 to highlight the day. Press P1 to deselect the day. After
P1 is pressed the day will disappear
a.
7 = Sunday, 1 = Monday….
b. To reselect the day’s press P4 or P5 until the day is flashing then press P1
13. Press P6 to save
14. Complete steps 5-13 to complete the remaining 11 slots or to exit setup move the program
switch to the up position
Alarm Settings
You can set up to (6) alarms to activate each day or you can set each alarm to only activate on
certain days of the week. Also you can set each alarm to sound the internal alarm, the external
alarm, or both. You can set the alarm duration from 1 sec. up to 4 min & 59 sec. The internal
alarm volume can be adjusted via the volume screw but note that it will affect all sounds from the
clock's speaker. The volume is adjustable from 0 to 102 decibels.
To Set an Alarm:
1. Enter Setup mode.
2. Press [P2].
3. Press
[P4 ↓ ] or [P5 ↑ ] to select the Alarm time slot:
Available Slots: 01, 02, 03, 04, 05, 06
Note: alarm slots must be set starting with Slot 01 first. Additional alarm slots must be
added in order. You cannot skip an alarm slot.
4.
Press [P6].
Press [P4 ↓ ] or [P5 ↑ ] to change the Alarm hour.
5.
Press [P6].
Press [P4 ↓ ] or [P5 ↑ ] to change the Alarm min.
6. Press [P6]. Press
[P4 ↓ ] or [P5 ↑ ] to change the Alarm type:
01=Internal, 02=External, 03=Both
7.
Press [P6]. Press
[P4 ↓ ] or [P5 ↑ ] to change the
alarm duration minutes.
8.
Press [P6]. Press
[P4 ↓ ] or [P5 ↑ ] to change the
alarm duration seconds.
9. Press [P6].
By default, the current Alarm slot will apply to all days of the week. If you want to deselect a day,
press
[P4 ↓ ] or [P5 ↑ ] to select the day (the day selected will begin flashing) then press [P2] to
deselect the day. The icon for the day will disappear. Repeat this step to deselect any other
days. To add a day back, follow the same steps and the icon
will re-appear.
10. Press [P6] to save the Alarm settings for the current slot. Repeat steps for any remaining
time slots
or move the Setup switch to the upper position to exit Setup mode.
See “Connecting External Signal Devices”
(pg. 26)
for instructions on how to connect bells,
horns or buzzers.