microBlox® Signal Splitter
Model uBSP-P-1
Acromag, Inc. Tel: 248-295-0880
- 9 -
http://www.acromag.com
- 9 -
https://www.acromag.com
How to Enable or Disable CJC and BLE Linking
DIP switches are used on this carrier to separately enable
BLE linking and CJC connection, and act identical to their
same settings as on standard uB back-panels.
MODULE
CJC SWITCH
SETTING
uB30 & uB40
Set CJC to ON
uB31 & uB41
Set CJC ON or OFF
uB32 & uB42
Set CJC ON or OFF
uB34 & uB35
Set CJC to OFF
uB37 & uB47
Set CJC to ON
Refer to table above and determine if the CJC must be
enabled for your module model and set CJC ON or OFF as
required.
Note that while this splitter also supports Bluetooth wireless technology enabled input models, its functionality as a
splitter cannot be configured wirelessly. However, it may function as a simple single channel I/O carrier for Bluetooth
wireless technol
ogy modules and you may configure a “
-
B” module on this carrier to drive its single AUX output using
Bluetooth wireless technology by enabling linking for the channel. Setting the channel BLE switch ON allows you to
link to the installed uBxx-B module from your smartphone or tablet (set it to OFF to block wireless access). Refer to
the figure above. Splitter outputs can only be configured via a wired USB or USB-OTG connection.
Input Connections
A single microBlox® input module plugs into sockets of this carrier and is retained by a spring-
loaded clip. Field input and AUX output connections are wired to carrier terminals in the
same fashion as input/output connections wired to the module when mounted on a standard
uB back-panel. Please refer to your specific uB module manual (see below) for information
on making input connections, CJC connections, or enabling Bluetooth wireless technology
linking.