46
Now the value “
Nbr ?
” is the new call number, to be selected with the
keypad, since the unit operates as per the settings in P9 (offset, range)
and automatically calculates the uniphone physical address.
The default ringtone for all apartments is ringtone #3.
P14 SEARCHING MISPLACED OR DEFECTIVE UNIPHONES
Srch
This program is used for searching a misplaced or defective uniphone. The
program helps detect which uniphone
may be overloading the line (cause it’s
damaged or its handset is not hung up), which may cause the whole system to
malfunction (impaired address selection, calling two different uniphones, etc.).
The function is disabled if P5 is active.
After entering the program t"
Nr.
" is displayed and the units starts automatic
search of uniphones - the call number of the uniphone being verified will be
displayed according to the parameters set in P9 (offset, range). When a
misplaced or defective uniphone is found, the unit will signal by a sound signal,
blinking of the display backlight and displaying its number. When the "
key
"
button is pressed, the unit starts searching other uniphones. The search can be
terminated at any time by pressing the "
#
" button.
When using non-ACO uniphones this function may not work properly. An
additional test is the line test - the P25 program
P15 ADDITIONALLY SUPPORTED NUMBERS
AddNo
This program is used to set the parameters for two additional numbers. Additional
numbers are used, for instance, to call one uniphone (one physical address) from
two different numbers dialled on the unit, or to dial a number outside the range
set in P9. Additional numbers can also be used when the door opening signal is
emitted by a uniphone different than the uniphone being called (most often the
uniphone with physical address "1" is the problem). In such case, program the
unit so that after dialling "1" the unit calls the physical address, such as "100"
(then the physical address "100" is set in the telephone in apartment "1").
Each additional number can be set in automatic opening.
