39
- “
To
”
last supported call number (by default "255").
The block diagram for programming parameters is shown in the figure below:
After entering the program, the display shows
"
Mov
"
and the current value of the
pre-set offset is displayed. At this point, a new offset value can be entered (0 to
998) or the "
key
" button pressed - to move to the next parameter without changing
this value. By entering 0, the unit will operate without number offset. The next
parameter is the
"
From
" -
the range from which the unit is to support uniphone
numbers (numbers dialled from the keypad - taking into consideration the pre-set
offset value). While the current value is displayed, a new parameter value can be
entered (1 to 999) or the "
key
" button pressed - to move to the next parameter
without changing this value. The last parameter is the
"
To
" -
the range to the unit
is to support uniphone numbers (numbers dialled from the keypad - taking into
consideration the pre-set offset value). While the current value is displayed, a new
parameter value can be entered (1 to 998) or the "
key
" button pressed - to move
to the next parameter without changing this value.
When the parameters have been saved correctly, "
Ready
" will appear on the
display. Pressing the "#" key at any time exits the program without saving the
changes. The unit indicates the values of the “
From
" -
“
To
" calling range based
on the pre-set offset.
Note: After entering any two-digit value (from 0 to 99) - press the "
key
" button to
confirm it and thus move to the next parameter. After entering any 3-digit value
(from 100 to 999) - the unit will save it automatically, without acknowledging by
pressing the "
key
" button, and will proceed to programming the next parameter.
PARAMETER DESCRIPTION:
-
Call number offset
(“
Mov
”):
Call number offset is used for the unit to support apartment with numbers
above 255 (up to 999 max). Set in P16 (bit6) whether the offset value is to be
added or subtracted from the value selected on the keyboard. By default bit6
is disabled (unit is set to subtract mode) and the offset value is set to zero (no
offset). When a call number is offset, the number of the first and last supported
call number is automatically offset.
