ACLAS EC320, User Settings Manual

Page: 40 / 79

E
C320 User settings manual
51
J-JY-EC320
Example: When the decoding information is "1234567890123ABC", the first thirteen bytes
"1234567890123" are output.
1. Check the character table to get the hexadecimal character corresponding to the decimal
data "13" as "0D"
2. Confirm that the setup code is enabled. If it is not enabled, please scan the “Enable Setup
Code” setup code (see section 1.5.2).
3.
Scan the “Cut length M before modification ” setting code
4. Scan the data setting code “0”, “D” in sequence.
5. Scan the "Save" setting code
6. Scan the "Transfer only segment" setting code
Transfer only the End segment
Example: When the decoding information is "1234567890123ABC", the last three bytes "ABC"
are output.
1. Check the character table to get the hexadecimal character corresponding to decimal data "3" as
"03"
2. Confirm that the setup code is enabled. If it is not enabled, please scan the “Enable Setup Code”
setup code (see section 1.5.2).
3. Scan the "Cut length N after modification " setting code
4. Scan the data setting code “0”, “3” in sequence.
5. Scan the "Save" setting code
6. Scan the "Transfer only End segment" setting code
Transfer only the Center segment
Example: When the decoding information is "12345678900123ABC", the middle four bytes
"0123" are output.
1. Check the character table to get the decimal data "10", "3" corresponding hexadecimal characters
are "0A", "03"
2. Confirm
that the setup code is enabled. If it is not enabled, please scan the “Enable Setup Code”
setup code (see section 1.5.2).
3. Scan the "Cut length N after modification" setting code
4. Scan the data setting code “0”, “3” in sequence.
5. Scan the "Save" setting code
6. Scan the "Cut length M before modification" setting code
7. Scan the data setting code “0”, “A” in sequence.
8. Scan the "Save" setup code
9. Scan the "Transfer only the segment" setting code