ACKERMANN 16-2000-700, Instructions For Use Manual

Page: 71 / 134

USER MANUAL 16-2000-700/701/702/703 Rev. 05/2018
8.11 System overload control
The system has work time restrictions, which protect it from overloading
(OVERLOAD). The restrictions depend on the power settings and the type of
procedure. In extreme conditions, overload control allows to at least 10 seconds of
work after 30 seconds of rest.
System overload is signalled by an acoustic signal and a message “System cooling”.
The system forces an interruption in the procedure until the indicator turns off (about
30 seconds).
Figure 31. Message: System cooling.
WARNING
Do not restrict system cooling during operation. This means the system cannot be
covered with anything during operation. If the system rests on a shelf, ensure that there
is at least 2 cm of clearance above the device.
A failure to ensure the appropriate cooling conditions will cause overheating to occur
earlier and to last longer.
Do not put any objects on the device. Due to the risk of flooding, the system should be
installed above and at a distance from fluids and irrigation conduits.
8.12 Program setting
All settings stored in the system memory by its users are saved independently for
each program. The saved programs remain in the system memory even when power
is switched off, and they can be recalled by pressing the bar with the program name
on the touch panel, then selecting an appropriate program from the list.
Page: 71 of 134