Chapter 5
85
Serial ATA Connectors
The six serial ATA connectors (SATA1-6) is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
IMPORTANT:
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data loss may occur
during transmission.
Fan Power Connectors
The fan power connectors (CPUFAN and SYSFAN1-5) support system cooling fan with +12V. When
connecting the wire to the connectors, always note that the red wire is the positive and should be connected to
the +12V; the black wire is ground and should be connected to GND.
IMPORTANT:
CPUFAN supports fan control. You can install Dual Core Center utility that will automatically
control the fan speed according to the actual CPU and system temperature. Fan/heat sink with 3
or 4 pins are both available for CPUFAN.
Chassis Intrusion Connector
The chassis intrusion connector (JCI1) connects to the chassis intrusion switch cable. If the chassis is opened,
the chassis intrusion mechanism will be activated. The system will record this status and show a warning
message on the screen. To clear the warning, you must enter the CMOS setup utility and clear the record.
Summary of Contents for Aspire Predator G7700 Series
