91
-
Change
Value
The minus key on the keypad is used to change the
value of the current item to the previous value. This
key scrolls through the values in the associated pick
list without displaying the full list.
+
Change
Value
The plus key on the keypad is used to change the
value of the current menu item to the next value. This
key scrolls through the values in the associated pick
list without displaying the full list. On 106-key Japa-
nese keyboards, the plus key has a different scan code
than the plus key on the other keyboard, but will have
the same effect.
F9
Setup
Defaults
Pressing F9 causes the following to appear:
Load Setup Defaults?
[OK] [Cancel]
If “OK” is selected and the Enter key is pressed, all
setup fields are set to their default values. If “Cancel”
is selected and the Enter key is pressed, or if the ESC
key is pressed, the user is returned to where they were
before F9 was pressed without affecting any existing
field values.
F7
Discard
Changes
Pressing F7 causes the following message to appear:
Discard Changes?
[OK] [Cancel]
If “OK” is selected and the Enter key is pressed, all
changes are not saved and setup is exited. If “Cancel”
is selected and the Enter key is pressed, or the ESC key
is pressed, the user is returned to where they were
before F7 was pressed without affecting any existing
values.
key
option
descriptiontion
Summary of Contents for Altos R710
