11
Trouble Shooting
Communications Error, no power to head, Display flickers and beeps continuously.
Check Control head cable for damage
Check that connectors are fully inserted
Check that cable is not running parallel to transmitting antennas
On units that have been in service, check for corrosion or foreign material.
Check power and ground to the PRM and that the IntelaBox is plugged in to the PRM.
Replace Control head cable, the cable is straight thru cat 5 style cable.
Alarm Displays Snooze Mode
Alarm is in snooze mode. Start up snooze mode allows the K9 Handler time to start the
vehicle, allow the Temperature in the vehicle to reach a safe level, and resolve any alarm
conditions. When the vehicle is running and the Temperature is at a safe level the status light
will turn on indicating monitoring of Temperature. (see owners manual)
Stall Sensor Alarm while driving or idling
.
Stall sensors adjustment is needed, check location of sensor it needs to be located over coils
in the alternator (see install manual) Note: if a sensor was not purchased, stall monitor
needs to be Disabled in Menu.
Temperature Sensors Show Different Readings
Display Shows Temperatures as Left, Average (in center),and Right
Sensors reading will vary with location and conditions. If it is necessary to prove the
accuracy of the sensors by place both sensors together in the same location, they will be
within less than one degree of another. (allow the sensors some time to adjust).
Sensor reading differences are caused by the following. (See install manual for placement)
Sun heating the car body.
Air conditioning flow.
Open windows or air leaks.
Sensors not in good airflow.
(772) 600-7574
Hours of operation Monday thru Friday
8:00am to 4:30pm EST
All rights reserved.AceK9.Com
