8
STEP 8 Window Drop Feature
Refer to Vehicle Specific Instructions for window down wire colors and locations.
Using the vehicle specific information as a guide, follow the instructions packed with your
window drop module.
The Protective Relay Module’s
Blue/Red
wires supply power to the Window Drop
Modules.
The Window drop modules are weather resistant Sealed Relay Modules “SRM”
designed to allow placement inside of doors.
The window drop module is designed for vehicles with a rear seat K9 Transporter and
window guards
, to contain the K9 and prevent unauthorized access to the vehicle. If dropping un-
guarded windows anti-theft system, equipment vault, and K9 transporter are recommended.
Weather Sensitive Window Switches.
When installing K9 Transporters' that replace factory
door panels, the switch should remain outside of the door skin, between vapor barrier and kennels
door panel. Cover switches with a plastic bag, opening pointing down, tied to allow condensation to
exit the bag.
STEP 9 Temperature Sensors Mounting
Never
where the K9 can damage the Sensors.
Never
within 12 inches of floor or headliner.
Never
in direct sunlight.
Never
directly in front of air vent.
Never
near equipment that radiates heat.
Never
behind trim.
Place sensors in good air flow entering the
kennel
DO NOT HEAT TEMPERTURE SENSORS WITH HEAT GUN
OR FLAME
!
The sensors should be set up to monitor the area
where the K9 is housed. Sensor location may vary with
vehicle setup and operation.
The Temperature Sensor cables are over 15 feet long so they can be adjusted to the most
effective locations.
Sedans or Pick Up Trucks
. with K9 transporter behind the front seats.
Mount one temperature in the airflow entering the transporter at front of the K9 transporter
on each side. A popular setup is attaching the sensors to each pillar trim (one on each side)
as long as there is good airflow into the Transporter.
Sport Utility and Wagons
. with K9 transporter behind the front seats.
Mount one Temperature sensor outside of the Transporter, approximately midway up in good
airflow, in front of the K9 Transporter and the other in opposite corner, in back of the K9
Transporter, in good air flow.
If area behind transporter is isolated from airflow the Sedan
method may be more appropriate.
Portable Kennels.
When using a portable kennel mount the sensors cattycorner to get the
best average Temperature.
Note: Averaging must be turned off if motioning multiple canines in separated
locations.
