AXS
–
Ramp Manual
AXS FL RAMP Manual rev 1
11
- Mount the leg hinge part at the second
platform, as far to the plastic end cap as
possible.
- Make sure the lip falls in slot.
- Tighten the bolts M8. (30 Nm)
- check the position of the T nuts
Flip over the gas spring mounting bracket, so
the ball is facing up instead of down.
Do not tighten the bolts entirely so the bracket
can still slide in the slot.
Mount the gas spring to the bracket of the leg
and move the other bracket to the furthest
extend and tighten the bolts
Mounting the right leg
Mount the turning point of the push rod at
platform 1 as far to the plastic end cap as
possible.
Mount the turning point of the leg as close to
the plastic end cap as possible, make sure the
lip falls in the slot before tightening the M8
bolts
- check the position of the T nuts
Place the holding blocks for the legs in such a
way they hug the legs when the ramp is
closed.
Adjust the length of the leg on both sides by
turning in or out the leg feet.
At a flat ground, with the ramp unfolded from
the vehicle, the legs should be approx.
1 cm
free
from the floor.
Fix the legs with the set screw.
And you are ready
1 cm free
