AXS
–
Ramp Manual
AXS FL RAMP Manual rev 1
19
Locate the exact position where
the ramp will be fitted at the floor.
The ramp should be placed as
close as possible to the door,
leaving 3-7cm clearance space
when the door is closed.
When the ramp must have a swing in stow
position:
Position the turning device in such a way that it
can turn inside but does not collide with the wheel
arch.
This only applies when the ramp must be able to
be turned to an inside stow position
See below sketch with approximately dimensions
In case the ramp should only be able to
swing out, you should position the swing
unit in such a way that it stays clear from the
door post in the swing out position
Important note:
Ensure that the ramp will stay free from the door
post if the door post curves in at the top of the
door. As you have not fitted the ramp at the
turning device yet, you should pull down a line
from the imaginary highest point of the ramp
projected at the doorpost down to the turning
device.
