AccuEnergy Accuvim II, User Manual

Page: 27 / 58

1
Ethernet Modual
j) Set HTTP port in the eighth setting page, such as 80. Press “V/A” key,
go to setting state. Users may set parameter in the pointed area, and
cursor starts at the first digit bit. After setting HTTP port completely,
press “V/A” key to affirm. Again press “P” key, go to the ninth setting
page for resetting mode. HTTP port’s default value is 80, and the user
defined range of port is 6000~9999. If the set port is not in range, the
set port will return default value.
Figure 3-12
k) Set resetting mode in the ninth setting page. Select “RESET” to reset
module. Select “NO” means not to reset module. Select “DEFAULT”
means load module with default settings and reset module. Press “V/A”
key, go to setting state, and the pointed area flashes. Press “P” key or “E”
key to select configuration mode, press “V/A” key to affirm.
Note: When configuring Ethernet module settings completely, users must
select “RESET” to restart module and new settings will take effect.