AccuEnergy Accuvim II, User Manual

Page: 21 / 58

15
Ethernet Modual
“E” key to select configuration mode, press “V/A” key to affirm. Again
press “P” key, go to the second setting page for IP Address.
Note: If you select the “AUTO” mode, please go to step k) directly and
reset module. Wait until the reset is finished and find the new IP address
in the following step.
Figure 3-5
d) Set IP Address in the second setting page, such as 192.169.1.100
as shown below. Press “V/A” key, go to setting state. Users may set
parameter in the pointed area, and cursor starts at the first digit bit.
After setting IP Address completely, press “V/A” key to affirm. Again
press “P” key, go to the third setting page for Subnet Mask.