519
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
servers, and all the accounting servers can be backup servers for each other. If
primary
is specified, then the specified RADIUS server will be the primary server.
Example:
Sets the RADIUS accounting server of IP address to 100.100.100.60 as the primary
server, with the accounting port number as 3000.
Switch(Config)#radius-server accounting host 100.100.100.60 port 3000 primary
20.2.2.18 radius-server authentication host
Command: radius-server authentication host <
ip-address
> [port <
port-number
>] [primary]
no radius-server authentication host <
ip-address
>
Function:
Specifies the IP address and listening port number for the RADIUS server; the “
no
radius-server authentication host
<IPaddress>
” command deletes the RADIUS
authentication server
Parameters:
<
ip-address
>
stands for the server IP address;
<
port-number
>
for listening port
number, from 0 to 65535, where 0 stands for non-authentication server usage;
primary
for primary server.
Command mode:
Global Mode
Default:
No RADIUS authentication server is configured by default.
Usage Guide:
This command is used to specify the IP address and port number of the specified
RADIUS server for switch authentication, multiple command instances can be
configured. The port parameter is used to specify authentication port number, which
must be the same as the specified authentication port in the RADIUS server, the
default port number is 1812. If this port number is set to 0, the specified server is
regard as non-authenticating. This command can be used repeatedly to configure
multiple RADIUS servers communicating with the switch, the configured order is
used as the priority for the switch authentication server. If
primary
is specified, then
the specified RADIUS server will be the primary server.
Example:
Setting the RADIUS authentication server address as 200.1.1.1.
Switch(Config)#radius-server authentication host 200.1.1.1
20.2.2.19 radius-server dead-time
Command: radius-server dead-time
<minutes>
no radius-server dead-time
Function:
Configures the restore time when RADIUS server is down; the “
no radius-server
dead-time
” command restores the default setting.
Parameters:
< minute >
is the down -restore time for RADIUS server in minutes, the valid range is
1 to 255.
Command mode:
Global Mode
Default:
The default value is 5 minutes.
Usage Guide:
This command specifies the time to wait for the RADIUS server to recover from
inaccessible to accessible. When the switch acknowledges a server to be inaccessible,
it marks that server as having invalid status, after the interval specified by this
command; the system resets the status for that server to valid.
Example:
Setting the down-restore time for RADIUS server to 3 minutes.
Switch(Config)#radius-server dead-time 3
