393
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command: ip rip receive version
{v1 | v2 | v12}
no ip rip receive version
Function:
Configure the RIP version to receive on the interface. The default setting is to receive
both RIP v1 and v2 packets; the “
no ip rip receive version
” command restores the default setting.
Parameters:
v1
and
v2
stands for RIP version1 and RIP version 2 respectively,
v12
stands for both
RIP version 1 and 2.
Default:
The default setting is
v12
, i.e., accept both RIP version 1 and version 2 packets.
Command mode:
Interface Mode
18.3.2.2.10 ip rip send version
Command: ip rip send version { v1 | v2 [bc|mc] }
no ip rip send version
Function:
Configures RIP version to send on the interface; the “
no ip rip send version
” command
restores the default setting.
Parameters:
v1 | v2
are both RIP version numbers;
[bc|mc]
is configured only for RIP-II for
specifying the sending method,
BC
for broadcast,
MC
for multicast. When configured to send
RIP-II packets, the interface sends RIP-II packets by
MC
(multicast) by default, packets are only
broadcasted when
BC
is set on the interface.
Default:
RIP-II packets are sent by default.
Command mode:
Interface Mode
Usage Guide:
When configured to send RIP-II packets, the interface sends RIP-II packets in
MC
(multicast) by default, packets are only broadcasted when
BC
is set on the interface.
18.3.2.2.11 ip rip work
Command: ip rip work
no ip rip work
Function:
Configures the interface to run RIP or not; the “
no ip rip work
” command disables RIP
packet sending/receiving on the interface.
Default:
After enabling RIP, RIP is enabled on the ports by default.
Command mode:
Interface Mode
Usage Guide:
This command is equal to “
ip rip input
” & “
ip rip output
” in function, the latter
two commands control the receiving and sending of RIP packets on the interface, the former equals
the total of the latter two commands.
Related command: ip rip input, ip rip output
18.3.2.2.12 ip split-horizon
Command: ip split-horizon
no ip split-horizon
Function:
Enables split horizon; the “
no ip split-horizon
” command disables split horizon.
Default:
Split horizon is enabled by default.
Command mode:
Interface Mode
