305
E
ES4710BD 10 Slots L2/L3/L4 Chassis Switch
Command: lease { [
<days>
] [
<hours>
][
<minutes>
] | infinite }
no lease
Function:
Sets the lease time for addresses in the address pool; the “
no lease
” command restores
the default setting.
Parameters:
<days>
is number of days from 0 to 365;
<hours
is number of hours from 0 to 23;
<minutes>
is number of minutes from 0 to 59;
infinite
means perpetual use.
Default:
The default lease duration is 1 day.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
DHCP is the protocol to assign network addresses dynamically instead of
permanently, hence the introduction of ease duration. Lease settings should be
decided based on network conditions: too long lease duration offsets the flexibility
of DHCP, while too short duration results in increased network traffic and
overhead. The default lease duration of ES4710BD is 1 day.
Example:
Setting the lease of DHCP pool “1” to 3 days 12 hours and 30 minutes.
Switch(dhcp-1-config)#lease 3 12 30
14.2.2.14 netbios-name-server
Command: netbios-name-server
<address1>
[
<address2>
[…
<address8>
]]
no netbios-name-server
Function:
Configures WINS servers’ address; the “
no netbios-name-server
” command deletes the
WINS server.
Parameters:
address1…address8
are IP addresses, in decimal format.
Default:
No WINS server is configured by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command is used to specify WINS server for the client, up to 8 WINS server
addresses can be configured. The WINS server address assigned first has the highest
priority. Therefore, address 1 has the highest priority, and address 2 the second, and
so on.
14.2.2.15 netbios-node-type
Command: netbios-node-type
｛
b-node|h-node|m-node|p-node|
<type-number>
｝
no netbios-node-type
Function:
Sets the node type for the specified port; the “
no netbios-node-type
” command cancels
the setting.
Parameters:
b-node
stands for broadcasting node,
h-node
for hybrid node that broadcasts after
point-to-point communication;
m-node
for hybrid node to communicate in point-to-point after
broadcast;
p-node
for point-to-point node;
<type-number>
is the node type in Hex from 0 to FF.
Default:
No client node type is specified by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
If client node type is to be specified, it is recommended to set the client node type to
