Accorroni AS COND, Installation Manual

Page: 4 / 56

4
This manual is an essential and integral part of the machine, therefore it must be followed, even in the case of
transfer of ownership or to another facility, and must be stored with care.
In case of damage or loss, another copy must be requested from the manufacturer.
The operator and specialized personnel are required to read and understand the contents of this manual.
The manufacturer declines all responsibility for damage to people, animals and things caused by:
o incorrect use of the machine;
o improper intended use of the machine;
o use of the machine that does not comply with the instructions in this manual;
o use that does not comply with laws, regulations, decrees, prescriptions, European, national, regional and
district ordinances.
The manufacturer also declines all responsibility if the machine is not installed or checked
periodically or repaired by service centres authorized by the manufacturer or by personnel specialized.
By specialized personnel we mean “maintenance technicians with specific knowledge of
heating in rooms where people are present".
This machine cannot be used by people (including children) with reduced physical, sensory,
mental or with little experience and knowledge of the machine in question unless the person is
been instructed on its use by the person responsible for its safety or operates under supervision
of the person responsible for safety.
IT IS STRICTLY FORBIDDEN TO USE THIS MACHINE IN THE PRESENCE OF AN
EXPLOSIVE ATMOSPHERE.
The system design, installation, commissioning, periodic checks and repairs of this machine must only be
carried out by qualified personnel.
In particular, attention is drawn to the obligations imposed by laws, decrees, rules, ordinances,
Prescriptions European, national, regional and local in matters of design, authorizations, installation,
controls periodicals, maintenance, combustion checks and atmospheric emissions, which the operator and
In the event of problems or malfunctioning of the machine, the operator must disconnect the power supply
machine and avoid any attempt to repair in order to avoid damage to the machine and / or to third parties.
See description in the TROUBLESHOOTING chapter of this manual.
Before any maintenance or repair work, remove the power supply to the
machine by selecting - O - on the electric control board
.
At the end of each heating season, the operator must request the intervention of specialized personnel to clean the combustion
chamber and the heat exchanger.
At the beginning of each heating season and, according to the deadlines set by law and regulations, the operator must have
the efficiency of all functional and safety parts of the machine checked by specialized personnel and have the combustion
checked.
The results of these interventions will be recorded in the "central log book".
The air filter, if provided, must be kept clean frequently to keep it clean.
It must be removed from its frame, blown with compressed air (see MAINTENANCE chapter) and put back in its frame.
When the air intake grille is dirty, it must be cleaned with a brush or vacuum cleaner without however removing it.
Explanation of graphic symbols on controls and alarm devices
Voltage
Heating
Intervention of the thermal
switch of the remote
Intervention of the safety limit
with manual reset
Burner off
Only ventilation
WARNING