Accelerated 6330-MX, Manual, Page: 35 / 140

3. Ensure the appropriate settings are entered into the new collapsible section generated for
the interface:
• The Enable Enable checkbox must remain selected.
• Interface Type Interface Type will stay Ethernet Ethernet.
• The default Zone Zone, "Any," suffices unless security policies necessitate a different selection.
• Device Device establishes which port(s) are assigned to the new interface.
• Expand the IPv4 IPv4 category to specify the Interface type and the desired address range.
• Additional settings for DNS DNS and DHCP DHCP configuration can be adjusted as necessary.
• Refer to the Failover Failover section for information on Connectivity Monitoring. Connectivity Monitoring.

This assumes a static (private) IP is desired for the interface.
VLAN Management VLAN Management
Before creating a Virtual LAN route for the MX-series router, be sure that its corresponding LAN
interface has been configured (per the steps on the previous page).
The interface's Device Device must be set to only include the port(s) that will be utilizing the VLAN
designation. Use the pull-down menu to specify an individual Ethernet LAN port, or choose the
"Bridge: LAN Bridge: LAN" option to assign all four ports.
Once the interface is created, it will be selectable as a Device in the VLAN's pulldown menu.
Separate VLANs by assigning each a unique ID ID number.

For guidance on how to create bridges with less than four ports, please refer to the Accelerated Accelerated
University University knowledge article.
Accelerated Notices
Page 35 Page 35 6330-MX / 6335-MX