Accelerated 6330-MX, Manual, Page: 114 / 140

MAC address-based Policy Routing with Dual MAC address-based Policy Routing with Dual
WAN WAN
Difficulty: Expert Expert
Goal Goal
To use the 6350-SR's cellular modem in tandem with its primary WAN Ethernet port, but only
allow devices with certain MAC addresses access to the cellular modem's Internet connection.
Setup Setup
This article assumes the LAN ports are operating under default settings, which provide DHCP
connectivity to devices connected to the 6350-SR's LAN ports. For more details on the default
settings of the 6350-SR, see the
Default Settings Default Settings
section of the 6350-SR User's Manual .
For this setup, you will need the 6350-SR with both a primary WAN Ethernet connection, and a
cellular modem connection.
You will also need to the MAC address of any client devices you want to always use the cellular
modem connection.
Sample Sample
The sample configuration below shows a 6350-SR with two Internet connections: a cellular-
based WAN connection through the 6350-SR's modem, and a broadband-based WAN
connection through the 6350-SR's WAN Ethernet port.
This setup shows two client devices on a 6350-SR's LAN ports, a VoIP phone and a laptop. The
VoIP phone and the laptop receive their IP address via DHCP from the 6350-SR.
The policy-based routing we are going to setup will accomplish the following.
1. The 6350-SR uses the Ethernet WAN as its primary interface.
2. The 6350-SR has a cellular modem connection, used as a secondary WAN interface.
3. The 6350-SR will drop any packets from LAN devices, excluding packets from the media PC,
and prevent them from going out the cellular modem interface.
Accelerated Notices
Page 114 Page 114 6330-MX / 6335-MX