Lanier R/C
Sukhoi SU 31M
Instructions
Locate the printed instrument panel gauges
and the clear lens. This will be installed in
one piece. Trim the clear lens to fit the
backside of the instrument panel; the lens will
stick through the holes. Trim the paper to fit
the clear and glue in place on the backside of
the clear with the instruments aligned with the
lens.
The instruments can now be glued to the
backside of the panel with the lens sticking
through the holes.
The panel will be glued in after covering. The
cockpit floor can be sheeted (wood not
supplied) or left open where the pilot can be
mounted in the fuselage, your choice.
Trim the clear canopy to the scribe line and fit
to cockpit. It will not be glued in place till after
the plane is covered. Be sure the cockpit is
screwed in place when gluing the canopy to
avoid warping the cockpit so it does not fit.
Landing Gear
Measure 3/8” behind the F2B bulkhead and
draw a line making sure it is perpendicular to
the centerline of the fuse. Then measure over
3” from the edge of the landing gear plate at
the front end on both side and make a mark.
This should line you up over the aluminum
angles.
10
