Device menu
33
Manual Alarm
Note
The menu is used to check the recording settings
in the event of an alarm, to trigger alarm outputs
manually and to test the settings. You can then
check and correct your settings in the playback
screen.
1. Select the camera by clicking the corresponding line.
2. Click
on
Trigger
to switch on the alarm manually.
Trigger
then changes to
No
for this camera.
3. Confirm the prompt by pressing
OK
.
4. When
Trigger All
is selected, then all alarms are
switched on manually.
5. Click
on
Clear All
to switch off all alarms simultane-
ously.
HDDs
Note
The device manages one 3.5" SATA hard disk
drive.
The installed HDD must be initialised before the
device can be used for recording. The device only
detects the HDD and its assignment after initiali-
sation has been made.
Warning
All data is deleted from the HDD during initialisa-
tion.
Ensure a data backup has been made in good
time beforehand.
Installing the HDD
1. Disconnect the device from the mains power and
open the cover.
2. Observe the applicable ESD guidelines when han-
dling electronic devices and ensure they are earthed.
3. Do not open the device in rooms with carpets or
other surfaces that can become electro statically
charged.
4. Avoid bodily contact with all components on the
PCB.
Warning
If you have questions regarding the information or
cannot find the information you need, please con-
tact your maintenance specialist.
5. Install the HDD and then connect it.
6. Reattach the cover and connect the device to the
mains power supply.
7. Switch on the device and start the HDD menu.
