Abus AZWG10200, Manual, Page: 7 / 40

7
General information
The AZWG10200-PSTN/IP converter is an IP/GPRS transmission device with two
transmission paths. The transmission device has an LAV interface that is suitable for
open and closed networks and a GPRS module for transmitting to the GSM network.
Depending on the version, the notifications can be imported from the analogue alarm
system either via the signal lines or via the converter.
Power supply
The AZWG10200-PSTN/IP CONVERTER is suitable for supply voltages from 10 to
28 V DC. It uses 70 mA when idle at 12 V DC, 85 mA when communicating via LAN
and 170 mA when communicating via GPRS.
Hardware modules
IP Ethernet (LAN)
The RJ45 Ethernet port on the AZWG10200-PSTN/IP CONVERTER supports
speeds of both 10 Mb/s and 100 Mb/s. The CONVERTER adapts to the network,
with 10 Mb the preferred speed because less power is consumed. Transmissions
can be sent in TCP and UDP.
IP/GPRS (GSM)
The GPRS module can send IP transmission in TCP and UDP. The registration on
the network, the signal strength and IP availability are constantly checked. The
status can be reported to the monitoring station via Ethernet. The ICCID
number of the SIM card can be sent to the monitoring stations with each test
notification, so the card can always be tracked. The antenna can be connected
via an integrated SMA connector.
A/B converter
The AZWG10200-PSTN/IP CONVERTER is equipped with an A/B converter for
analogue SIA, Contact ID and Telim alarm systems in order to link them easily
to the modern IP networks and monitoring stations. The CONVERTER reads the
alarm notifications with Telim, Contact ID or SIA, including text, from the alarm
system, saves them, converts them according to the DC-09 IP protocol and
then checks and sends them to the monitoring station. The analogue Telim
protocol can be converted to VdS 2465 IP and SIA DC-09. All other protocols
are converted from analogue to the same digital protocol, i.e. SIA analogue is
converted to the digital SIA DC-09 protocol and CID analogue to the digital
CID DC-09 protocol.
Alarm transmission
The AZWG10200-PSTN/IP CONVERTER sends the notifications in VdS 2465, Contact
ID DC-09 and SIA DC-09 protocols as needed. VdS 2465 and SIA DC-09 also support
text. The DC-09 protocol is an open, standardised protocol that is supported by many
surveillance services around the world. Depending on use, transmissions can be
encrypted with an AES 128, AES 192 or AES 256 key. VdS 2465 supports encryption
with AES 128.
EN-compliant transmission