Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
Model: ADGAZEBO33
21/09/23
1.00
9
SIDE FLASHING - FRONT DETAIL
NOTE:
Leave the protective plastic on
TR36
flashing until
fastening, It’s good to mark on.
Trimming shown is for the
Left flashing. Right is
the same but ‘mirrored’.
1.
Mark out and cut away 15mm from the top
and bottom sides using tinsnips (offcuts shown in
grey).
2.
You’ll be left with a tab as shown. Use “Sheet
Metal Locking Pliers” to easily fold it 90 degrees.
3.
Check fit by placing flashing along the side of
roof panel.
• Bent tab hard up against front.
• Top face sits on two sheet ribs.
• Bottom face covers the rear flashing.
15
90
o
SIDE FLASHING - REAR DETAIL
0.
TR36
flashing will overhang roof panel at the
rear and we’ll need to trim to make the gutter fit
later.
NOTE: If the flashing is the same length as the
roof panel you don’t need to trim the top.
1.
Mark off where ‘top skin’ end is against the top
side of the flashing.
Then continue 30mm down the side.
2.
Mark off where the rear ‘Z’ flashing is against
the bottom side of the flashing.
Then continue 40mm up the side.
3.
On the side mark a line to join these points as
shown.
4.
Take the flashing down off the roof and trim
using tinsnips (offcuts shown in grey).
REAR LEFT UNDERSIDE VIEW - Rear & side
beams not shown.
1
2
30
40
0
