Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
Model: ADGAZEBO33
21/09/23
1.00
13
DOWNPIPE
NOTE:
The method shown is to mount a simple
full height straight downpipe
RWG21
. An 80 to
90 mm adapter
RWG29
is supplied if you wish to
join into existing system instead.
1.
Fit both downpipe clips
RWG23
to the
centreline of the post at the positions shown.
2.
Fasten the clips to the posts using tek screws
FAST100
(no neoprene washer).
Be careful not to over-tighten and damage.
Predrilling may be helpful.
3.
Cut the downpipe to length.
4.
Place the dropper
RWG22
into the top of the
downpipe and fasten and seal, press into clips
and slide up until it touches the underside of the
gutter.
5.
Straighten and then mark the four fastening
holes and the centre.
6.
Cut out the centre hole with a 70 mm hole saw.
7.
Seal the dropper to the underside of the gutter
and rivet at all corners.
8.
Secure downpipe to clips using two tek screws
FAST100
(no neoprene washer). Be careful not to
over-tighten and damage.
CL
1
2
Add this tek as
per
3
on page 7
Immediate maintenance required!
Check and clean swarf from surfaces. Swarf will rust and if not cleaned away can permanently
discolour the structure.
