Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
Model: ADGAZEBO33
21/09/23
1.00
10
5.
Refit the flashing, and fasten using pop rivets
FAST102
at the locations shown.
Only at the rear, on top, use teks with neoprene
washers
FAST101.
FRONT LEFT UNDERSIDE VIEW
FRONT LEFT TOP VIEW
6.
Repeat these steps for
the other side flashing. Just
remember to make the
mirrored version.
SIDE FLASHING - FASTENING
REAR LEFT UNDERSIDE
VIEW
1.
At the front, take an outside measurement from
the left to the right flashing.
Trim the front flashing
TR37
to this length.
2.
Cover the front edge of the roof and flashings.
Carefully lift over gaskets.
3.
Fasten with pop rivets
FAST102
along the
underside are shown.
Fasten with tek screws with neoprene washers
FAST101
along the top.
To increase weather protection at the front do the
following.
A.
Turn up pans of sheet 15 degrees using “Sheet
Metal Locking Pliers”
B.
Installing foam gaskets
RWG28
within 90mm
of the front edge.
Some trimming may be required to fit at ends.
Apply silicone to the face that sits in the pan.
FRONT EDGE
FRONT FLASHING
FRONT UNDERSIDE VIEW
