Troubleshooting
Most problems with the system can be quickly solved by following the
instructions below. There are more tips and information on troubleshooting on our
website.
Transmitter
Pager
EN
Pager charger
34
Chapter 4
Troubleshooting and other information.
Chapter 4
Troubleshooting and other information.
35
If
Try this
Pager symbol is
lit whilst the pager is
vibrating and beeping
•
Pager has lost radio contact with a trans-
mitter. The LED position on the pager will
indicate which transmitter is at fault if you
have several transmitters. Move to within
range of the transmitter.
Pager
symbol is lit
whilst the pager is
vibrating and beeping
•
A transmitter in the system is indicating
an error. The LED position on the pager
will indicate which transmitter is at fault
if you have several transmitters. See
Troubleshooting transmitter
on p. 14.
Pager symbol is
white, whilst the pager
is vibrating and beeping
•
Pager has less than two hours of battery life
left. Charge batteries by putting the pager
in its charger. A full charge takes 6 hours.
Pager symbol is red,
whilst the pager is
vibrating and beeping
•
Battery in pager is wrong type, incorrectly
fitted or flat. Check how the battery is fitted
or replace, see
Changing batteries
on p. 12.
Pager not emitting any
sound whilst the
symbol is lit
•
Pager sound switched off. Slide sound
switch upwards to restore sound. Switch is
on right side of pager (see overview).
If
Try this
Transmitter status
indicator light
flashing red
•
The transmitter battery level is low. Replace the batteries
if the transmitter is battery powered. Charge the
batteries if it is mains powered.
Important!
If the transmitter is battery powered, use alkaline
AAA batteries only. If the
transmitter is mains powered, use rechargeable
NiMH AAA batteries only. NEVER mix NiMH batteries with
alkaline as the unit can overheat.
Transmitter status
indicator light
flashing purple
•
Batteries in transmitter are wrong type or fitted
incorrectly. See above for correct configuration and
fitting of batteries.
If
Try this
Pager cannot be charged
•
Check that the pager is correctly
placed in the charger. The LED by the
-symbol will blink/light up to show
that it’s charging.
•
Check that the charger is connected to
mains power. The LED by the -symbol
is lit to show that it is connected. If the
LED blinks, it is using the backup battery.
Reserve battery in charger
not working and charger
-symbol off
•
Check batteries are correctly fitted and
charged. Charge or replace batteries,
see
Changing batteries
on p. 12.