DOOR/WINDOW TRANSMITTER
Cat. No. 46A00-1
INSTALLATION
ENGLISH
DI-021-SY461-05A
AR2243
(46I00-1)
WARNINGS AND CAUTIONS
• Read and understand all instructions. Follow all warnings and instructions marked on the product.
• Do not use this product near water - e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet
basement, or near a swimming pool.
• Never push objects of any kind into this product through openings, as they may touch dangerous voltages.
• Never install communications wiring or components during a lightning storm.
• Never install communications components in wet locations unless the components are designed specifically
for use in wet locations.
• Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network interface.
• Use caution when installing or modifying communications wiring or components.
• SAVE THESE INSTRUCTIONS.
PROGRAMMING JUMPERS
There are three jumpers inside the 46A00-1 that are used to program the unit. Remove Jumpers as
needed for installation.
IN
OUT
Jumper 3
Read Switch
Tilt Switch (Mercury)
Jumper 2*
Instant Transmission
1 Minute Delay Transmission
Jumper 1**
1 ms
500 µs
* The 46A00-1 never looks at Jumper 2 unless Jumper 3 has been removed since it only adds a delay if you
are in Tilt sensor mode.
** This jumper must remain ‘in’ for normal operation.
Enrolling the 46A00-1
To enroll the 46A00-1, put the 45A00-1 Wireless Receiver in to Setup mode and advance to an unused address
location. Activate the reed switch by removing the magnet from the transmitter for 1 second, then replacing it.
Refer to the Installation Instructions for the 45A00-1 for additional information.
DESCRIPTION
The 46A00-1 Door/Window Transmitter is a 3 Zone supervised wireless
contact that works with the Leviton 45A00-1 Wireless Receiver.
FEATURES
• 3 Zone Transmitter: Easily protect any three zones in close proximity of
each other. This reduces the expense of having to buy three sensors to
protect three different zones in close proximity.
• Tilt switch for garage door: Protects garage doors with its ‘tilt’ sensing
capability. Reports ‘Not Ready’ and ‘Secure’ condition based on position
of garage door. Easy installation…no magnet needed.
• Programmable tilt sensor output: Can instantly send a ‘Not Ready’ signal
when the garage is opened OR can hold back the ‘Not Ready’ signal for 1
minute adding extra time to the entry delay.
• Low Battery LED indicator: Flashes every 5 seconds when a low battery condition is detected. Additionally it
sends a signal to the 45A00-1 Wireless Receiver and Leviton controller for battery low trouble notification.
• Built-in reed switch and 2 hardwire inputs: Use one sensor for 3 zones.
• Built in tamper switch: Alerts you when the cover is removed.
WEB
VERSION
