Pair transmitter to pager
1
To link a transmitter, press and hold the pager acknowledge button. Release
the button when the two centre diode lights start to flash.
2
Press the transmitter test button within 10 seconds to pair the units.
3
A diode light on the pager will come on to show that the transmitter is linked:
Orange diode - Transmitter 1
Yellow diode - Transmitter3
Green diode - Transmitter 2
Red diode - Transmitter 4
Repeat steps 1-3 to link a new transmitter. You can link up to 4 units.
Delete linked transmitter
1
Press and hold the pager OK button until the two centre diodes begin to
flash. Press the button three times in quick succession.
2
All the diodes will flash twice to show that the linked transmitters have been
deleted. This action cannot be cancelled.
Key to pager signals
The pager shows whichs ensor and transmitter has activated by using
various diode colours and flashing patterns.
Note:
The pager diode colours and flashing pattern differ depending on
whether you have
ONE
or
SEVERAL
transmitters linked to the system.
System with ONE transmitter
- Each sensor has a dedicated diode colour
EN
System with
- Each transmitter has a dedicated diode colour
SEVERAL transmitters
- Sensors are identified by flashing pattern
30
Chapter 2
Install pager.
Chapter 2
Install pager.
31
2
1
1
2
3
4
3
2
1
Activated transmitter Activated sensor Colour and flashing pattern
Transmitter 1
Sensor 1
Orange
Transmitter 1
Sensor 2
Green
Transmitter 1
Sensor 3
Yellow
Transmitter 1
Test button
Red