Abicor Binzel PP, Operating Instructions Manual

Page: 34 / 72

EN - 16 BAL.0212.0 • 2018-07-16
8 Maintenance and cleaning PP
8.2 Replacing liner in torch neck
1
Remove torch neck
(1)
from torch seat
(7)
by unscrewing the nut
(2)
.
2 Lift off clamping cap (4) and swing out seat clamp (6) laterally.
3
Unscrew counter nut
(5)
from the inlet nozzle
(3)
.
4 Remove inlet nozzle (3) from PP body toward the front by unscrewing it and replace it.
5 Screw in inlet nozzle (3) until a short distance in front of the wire feed roll and secure it in
this position with the counter nut (5) .
6 The inlet nozzle (3) is mounted in reverse order.
1 Torch neck
2 Nut
3 Inlet nozzle
4 Clamping cap
5 Counter nut M3
6 Seat clamp
7 Torch seat
8 Liner (plastic)
Fig. 7 Replacing liner in torch neck
1 4
6
2
7 8
3
5
NOTICE
• In the case of bent torch necks, a liner (plastic) (8) (outer diameter D = 4.0 mm) must be
mounted additionally between inlet nozzle (3) and contact tip.
• The actual length of the liner (plastic) (8) must be adjusted, depending on the
application.