BAL.0153 • 2018-08-24
EN - 13
ALPHA FLUX
10 Disposal
9.3.1 Replacing the neck liner
Fig. 2 Mounting the torch neck liner on page EN-7
1
Unscrew the clamping screw at the handle, remove the torch neck
(1)
and pull out the old
torch neck liner
(3)
.
2
Insert the new neck liner from the rear into the torch neck
(1)
up to the stop and measure the
length.
3
Shorten the torch neck liner at the front side until the inlet nipple
(2)
terminates flush at the
torch neck
(1)
and debur the edge.
4
Slide the torch neck
(1)
into the handle as far as it will go and secure it with the clamping
screw.
9.3.2 Shortening the spiral liner
Fig. 3 Mounting the liner on page EN-8
1
Lay down the cable assembly straight.
2
Unscrew retaining sleeve
(6)
/ clamping bolt
(7)
.
3
Insert the new liner
(5)
.
4
Measure the excess length of the liner:
• subtract 15 mm in case of a central connection
• add 1 mm in case of a Lincoln connection
5
Pull out liner
(5)
.
6
Shorten the front side of the liner by the calculated length
7
Debur the edge
8
Insert the liner
(5)
.
9
Tighten retaining sleeve
(6)
/ clamping bolt
(7)
.
10 Disposal
NOTICE
• New still unused liners have to be shortened to the actual length of the cable assembly.
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.