Visit:
www.abisupport.com
12
Fig 29.
Fig 28.
Fig 31.
Fig 26.
Fig 30.
Fig 27.
Fig 25.
Fig 22.
Fig 23.
Initial Setup (cont'd)
axle shaft
bent cotter pin
The long tube portion of
the hub (with the small
hole going thru the side
of the hub) faces inward
toward the gearbox on
the axle.
M6x45 hex head
bolt and washer.
washer and
M6 locknut.
28mm shim
20mm washer
Fully tighten both nuts securing curved guard to main
support frame (from
Fig 6
) once flow control bracket
hole is centered in slot on curved guard.
Re-thread the flow control adjustment knob and
washer thru the curved guard slot and into the
threaded hole on the flow control assembly bracket.
Fig 21.
Fig 20.
Slide flat plate on flow control assembly
into grooves on mobile shutter attached
to the bottom of the hopper.
Rotate curved guard up or down as needed to get
threaded hole in flow control assembly bracket
centered in slot of curved guard.
Curved guard.
Rotate flow control assembly bracket
up and behind curved guard.
