ABC Design Tandem, Instructions For Use Manual

Page: 9 / 38

EN - 05
Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product
or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the pushchair
a. Squeeze the pushchair together by applying slight pressure and pull the transportation lock up.
b. Pull the pushbar towards you until the folding mechanism opens and engages on both sides.
2. Mounting the front wheel blocks
b. Push the wheel block onto the axis until it clicks into place.
c. To remove the wheel block, press the catch on the bottom of the wheel block joint and pull the wheel
block off the axis.
3. Mounting the rear axle and rear wheels
a. Fit the rear axle onto the frame.
NB: The brake levers must be pointing rearwards.
b. Place the rear wheels on the axis.
Secure the wheels with the retainers (1), fit the protective caps over them (2) and place the wheel caps (3)
in the rim.
4. Using the brake
Press the bar down to engage the brake and up to release the brake.
5. Detaching the guard rail
Press the buttons on both sides to release the guard rail then pull the rail upwards to remove from its
bracket.
6. Fastening the harness
To fasten the harness push the two plastic catches (1) together until they engage.
Adjust the strap to a setting where the baby is held in the correct position.