2-1
Questions?
Refer to Page 10-9 For Technical Support Instructions.
Chapter 2: Using the Monitor
Barcode Scanner
The barcode scanner enables you to scan the information into the monitor instead of manually entering the data using
the keypad. Scanning the barcode on the test strip foil packet automatically enters the test strip information (calibration,
control range, lot number and expiration date). The scanner may also be
used to enter Operator ID, Patient ID, control lot number, comment code
and free text fields. To operate the
monitor:
Step 1: Place the barcode on a flat
surface.
Step 2: Hold the barcode scanner
3-12 inches from the barcode to be
scanned, and at a 30 to 135 degree angle to the barcode.
Step 3: Press and hold down the Scan button until a visible red beam is emitted by
the monitor.
Step 4: Slowly move the monitor, if needed, so that the red beam is directly over
the barcode.
Step 5: The monitor will beep in acknowledgement when it accepts the barcode.
When first learning to use the barcode scanner, some precautions should be taken. It is important that you place the
object to be scanned on a flat surface or hold it, by itself. This will prevent other items from being accidentally scanned.
If data has been manually entered, scanning data will erase the manually entered data (unless the Enter key has been
selected to confirm manual entry) and replace it with the scanned data. This entry will be considered scanned. Upon a
successful barcode scan, this system will automatically proceed to the next screen. The scanning beam shuts off in three
seconds if nothing is detected.
Data Entry Keypad
The data entry keypad allows you to enter identification numbers and letters (only the 26 letter
English alphabet) or to select an option that appears on the display. The keypad contains a 10 digit
telephone-style keypad with the keys for the numbers 0-9. The 2-9 keys also have letters printed
below the number. The keypad also has six special keys, including a scan button, on/off button,
backlight/alphanumeric, clear, menu, and enter key.
Scan
Press this button to operate the bar code scanner. If the audible indicator is enabled, the monitor
will beep once a barcode has been successfully scanned. Continuing to hold the scan button will
display the scanned barcode on the display until the button is released. If no information is scanned
after 3 seconds, the scanner will turn off.
30°
135°
Using the Monitor
IMPORTANT
: Never look into the barcode scanner beam or point it toward anyone’s
eyes. The beam could cause permanent damage to the eye. CDRH
Class II/IEC Class 2 Laser Product: Avoid Long Term Viewing of Direct
Laser Light.
Note:
If you hold the Scan button for three seconds, the scanner stops.
Reposition scanner and try again. Optimal distance depends on bar
code type.