6
…1
CHARTS AND PENS
To enable chart reload procedure press the
key to stop recording. Remove
the old fanfold chart from the cassette.
Load new fanfold chart – see Fig. 1.3 (refer to Section 6, Spares List for part
numbers). When a new chart is fitted and the cassette replaced, press the
key. The chart moves forward approximately 30mm to take up any slack.
This frame is displayed momentarily when chart loading is complete.
When the
key is pressed, recording ceases and the chart stops.
The print head moves from side to side printing at the 40% and 60% positions
on the chart to enable adjustment onto the time line.
Press the
key to move chart to the correct position to allow printing of time
to correspond to major time lines. Recording resumes when the
key is
pressed.
Select one of three pre-defined chart speeds. The values shown are the
company standard settings.
1.2
Loading a Fanfold Chart – Fig. 1.3
Select the
Load Chart Page
– see Fig. 1.1.
LOAD CHART
PAGE
FOR ADVANCE TO TIME
LINE PRESS ENTER
SELECT CHART SPEED
SPEED 1: 0mm/h
SPEED 2: 20mm/h
SPEED 3: 120mm/h
ADVANCE TO CORRECT
TIME LINE
Time Line Advance
OFF
TO START RELOAD
PRESS ENTER
LOAD NEW ABB CHART
XX.Xm CHART LOADED
XX.Xm REMAINING
Time Line Advance
ON
