Tension Electronics PFEA113, User Manual
Chapter 6 Fault-tracing
6-6
3BSE029382R0101 Rev C
6.8 Warnings and Errors Detected by the Tension Electronics
6.8.1 Errors
6.8.1.1 Flash Memory Error
•
Replace PFEA113.
6.8.1.2 EEPROM Memory Error
•
Replace PFEA113.
6.8.1.3 Supply Error
IP 20-version (unsealed):
When the PFEA113 is connected to the 24 VDC power supply the voltage between terminals
X1:1 and X1:2 should be 18 - 36 V.
•
If the voltage is lower than 18 V:
–
Check the power supplies rating. Rating should be 18-36 V DC.
–
Check that the power supply has sufficient capacity. See power requirements in
Section 2.13.2 Relay Board PXKB 201.
•
If the power supply has sufficient capacity, check cabling and cable resistance between
power supply and PFEA113.
•
If power supply and cabling are correct, the tension electronics is probably defect.
Replace PFEA113.
IP 65-version (NEMA 4):
•
Check the mains voltage connected to terminals X9:1 and X9:2.
Mains voltage must be:
85 - 264 V AC (100 V -15% to 240 V +10%)
Frequency range: 45 - 65 Hz
Summary of Contents for PFEA 113
Page 32: ...Tension Electronics PFEA113 User Manual Chapter 2 Installation 2 16 3BSE029382R0101 Rev C ...
Page 92: ...Tension Electronics PFEA113 User Manual Chapter 5 Maintenance 5 2 3BSE029382R0101 Rev C ...
Page 104: ...Tension Electronics PFEA113 User Manual Chapter 6 Fault tracing 6 12 3BSE029382R0101 Rev C ...
Page 259: ......