64
PCS100 UPS-I
User Manual
7.3
PCS100 Inverter Display Boards
The PCS100 Inverter modules contain their own display boards which contain the RUN and OK LEDS, as well as 2 x
7 segment LED displays.
The 7 segment displays show the individual module identification number (1
–
32), however if there is an error
condition they will flash alternately every 500 ms the module identification number and an error code. On start-up
they will show L0 and L1 indicating the states in the start-up sequence.
7 segment LED display
OK LED
RUN LED
Figure 7
-
14: Module Status LEDs
7 segment LED display
Product Status or Description
OFF
Not powered
“
L0
” and the module number
FLASH (50% duty, 1sec
period)
Booting.
This is normal just after power up.
“
L1
” and the module number
FLASH (50% duty, 1sec
period)
Configuring.
This is normal during start up after booting (L0) has completed.
“
ou
” and the module number
FLASH (50% duty, 1sec
period)
The module is running, and it has been configured as an inverter (output).
This is displayed for about 2 minutes after configuration (L1) is completed.
“
E0
” and the module number
FLASH (50% duty, 1sec
period)
A fault has occurred in the module.
See error message on GDM
1 to 32. Module number
The module is running.
This is displayed after configuration (L1) is completed.
“
E1
” and the module number
FLASH (50% duty, 1sec
period)
Problem starting the module
–
invalid parameter/s.
No communication with DSP (digital signal processor) in the master module.
Possible DSP hardware failure.
“
E2
” and the module number
FLASH (50% duty, 1sec
period)
Problem starting the module
–
invalid parameter/s.
“
u0
” and the module number
FLASH (50% duty, 1sec
period)
Requested operation mode: using internal dip switch setting.
“
u1
” and the module number
FLASH (50% duty, 1sec
period)
Requested operation mode: rectifier/input module (not applicable to
PCS100 UPS-I).
“
u2
” and the module number
FLASH (50% duty, 1sec
period)
Requested operation mode: inverter/output module.
Table 7
-
12: 7 segment LED displays
Summary of Contents for PCS100 UPS-I
Page 143: ...PCS100 UPS I User Manual 143 ...