![background image](http://html.mh-extra.com/html/abb/microflex-e190/microflex-e190_user-manual_5164085.webp)
Electrical installation: input / output 85
is set to match the input resolution. In all other cases there is a propagation delay of
up to 125 µs.
Use one of the following methods to configure X7 as an encoder output:
• In Mint WorkBench, choose the Drive Setup tool and proceed to the Motor
Feedback page. In the Simulated Encoder Output 0 area, click in the Encoder
source channel drop down and choose one of the encoder sources 0, 1, or 2 as
described above. Proceed to the end of the wizard and follow the instructions to
save the changed parameter.
• In Mint WorkBench, choose the Parameters tool and expand the Encoder family.
Click the EncoderOutChannel entry, then click the value next to
EncoderOutChannel (Encoder Channel 0). Choose one of the encoder sources 0,
1, or 2 as described above. On the menu, choose Tools, Store Drive Parameters.
• In Mint WorkBench, choose the Edit & Debug tool. In the Command window enter
the command:
ENCODEROUTCHANNEL(0)=
n
, where
n
is 0, 1, or 2, as described
above. On the menu, choose Tools, Store Drive Parameters.
OPT-MF-201 Resolver adapter
The optional resolver adapter OPT-MF-201 allows a motor with resolver feedback to
be connected to the MicroFlex e190. See page
for details.
Summary of Contents for MicroFlex e190
