3)
Tighten the locking screw securing the width guides in the right position.
4)
Insert the plate into the feed opening until the printer beeps.
6.3 TURNING ON THE PRINTER
Turning On The Printer.
On the display will be visualized the message
and afterwards the message
REMIND
If the width guides are too close together, the plate will not be feed properly. It is important to adjust the
width guides so that the plate is not loose but it moves smoothly to the left. If the width guides are too
loose, the plate will be fed not straigth, yielding poor print results.
Always make sure the guides are properly aligned with the plate.
NOTICE
Don’t tighten the locking screw too much. Don’t loosen the locking screw too much, only enough to
adjust and fix the guides in the proper position.
REMIND
When printing more than one plate, before loading another plate, wait until the printer
ejects the previous plate and beeps and until the message PRINTING disappears from the
display
.
At this stage you can load the next plate
PLEASE WAIT…
VERSION X.X
PRINT READY
PLATE SBLACK
Summary of Contents for HTP500
Page 1: ...User guide HTP500 V2 Thermal transfer printer ...
Page 12: ......
Page 66: ...1SNC160010M0202 10 2012 ...